Returning a sled from manual or DTC mode After setting a sled to manual or DTC mode, you can move the sled from manual or DTC mode to automation mode. Performing the following ensures that the right configuration is on this sled. First verify the access information then remediate the sled configuration. Child TopicsVerify the sled access configurationVerify the sled access configuration before returning it from manual mode because it could have been changed while the sled was in manual mode. Remediate the sled access configurationAfter you verify the sled access configuration, you must remediate any of the differences. Remediate the sled configurationAfter you complete the prerequisites, you must remediate the sled by adjusting any settings that could have changed when the sled was in manual mode.